Everything below concerns Aspartimide. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Last reviewed on 2026-06-24. Where a claim depends on a specific study, the study is described rather than over-claimed.
Identity and purity are checked by reversed-phase high-performance liquid chromatography, usually with ultraviolet detection near 214 nanometres, where the peptide bond absorbs. Mass spectrometry confirms the expected mass and reveals whether truncation products or adducts are present. Acid hydrolysis followed by amino acid analysis gives the residue ratio, which should approximate one alanine, one glutamate, one aspartate and one glycine. Counter-ions such as acetate or trifluoroacetate remain in the dried product and lower net peptide content, so a stated purity figure on a label does not by itself describe how much peptide a vial holds.
Regulatory treatment differs by country. No formulation of epitalon holds a marketing authorisation as a medicine in the United States or the European Union, where material sold for laboratory use is handled as a research chemical and is not intended for human consumption. In Russia, several short peptide preparations from the same institute's peptide series are registered medicinal products, and epitalon appears in that national context. Elsewhere it is frequently offered as a cosmetic ingredient, a category with lighter requirements. Advertising claims about longevity or disease prevention are restricted in most jurisdictions, which limits how sellers describe the compound.
Material supplied for laboratory use is normally a lyophilised white to off-white powder that dissolves readily in water and in isotonic saline. Lyophilised cakes are hygroscopic and should be equilibrated to room temperature before opening to limit condensation on the solid. Solutions are typically prepared at milligram-per-millilitre concentrations and divided into single-use aliquots, because repeated freeze–thaw cycles degrade short peptides. Aqueous solutions are far less stable than the dry powder, and identity is usually verified by mass spectrometry alongside purity estimation from reversed-phase high-performance liquid chromatography.
Epitalon is a synthetic linear tetrapeptide with the sequence alanine–glutamate–aspartate–glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and the calculated mass is approximately 390.35 g/mol. The compound is made by solid-phase peptide synthesis rather than extracted from tissue, although early work described it as a short fragment of a peptide fraction obtained from bovine pineal extract. In the research literature the spelling epitalon and the variant epithalone both appear, while AEDG is the standard code used in peptide nomenclature.
Several names circulate for the same molecule, including epitalon, epithalone, epithalamin tetrapeptide, and the sequence code AEDG. A CAS registry number, 307297-39-8, is commonly cited for it, though catalogue entries should be checked against supplier documentation because mislabelled records occur. In its usual form the peptide carries free amino and carboxyl termini and is neither glycosylated nor lipidated. Researchers distinguish the defined tetrapeptide from epithalamin itself, a crude pineal preparation containing many peptides that is not chemically characterised.
| Property | Value | Notes |
|---|---|---|
| Storage temperature, solid | Approximately -20 C | Sealed, desiccated, protected from light |
| Typical identity method | Electrospray mass spectrometry | Protonated ion expected near 391 |
| Typical purity method | Reversed-phase HPLC | Ultraviolet detection near 214 nm |
| Common synonyms | Epithalon, epithalone, AEDG | Spelling variants appear in supplier catalogues |
| Solution stability | Days at 2-8 C | Hydrolysis and deamidation limit shelf life |
Because epitalon has no pharmacopoeial monograph, quality assessment depends on supplier documentation and independent testing. Certificates of analysis typically report a purity figure from a single chromatographic run, a measured mass and sometimes an appearance description, but methods and acceptance criteria are not harmonised across vendors. Third-party laboratories can repeat identity and purity measurements, and mismatches between labelled and measured peptide content have been described for research peptides generally. What constitutes adequate identity confirmation for a molecule of this size stays an open question, since mass agreement alone does not separate closely related sequences.
Identity testing for epitalon relies on reversed-phase high-performance liquid chromatography for purity and mass spectrometry for mass confirmation. Because the sequence contains no tryptophan or tyrosine, ultraviolet detection at 280 nanometres is insensitive, so chromatographic methods usually monitor absorbance near 214 nanometres, where the peptide backbone absorbs. Electrospray ionisation or matrix-assisted laser desorption/ionisation then checks the intact mass against the expected value near 390 daltons. Peptide mapping or amino acid analysis after acid hydrolysis can supplement these measurements, although such confirmatory work is seldom reported on commercial certificates of analysis.
The compound is described in the literature as a derivative of epithalamin, a preparation obtained from bovine pineal tissue. Work on this peptide family was carried out mainly by a research group in Saint Petersburg beginning in the 1980s, and the substance was later registered for clinical use in Russia under the name Epitalon. Outside that region it is generally treated as a research chemical rather than an approved medicine. Statements about its biological activity rest on a relatively small number of studies, and independent replication remains limited.
In its supplied form epitalon is a white to off-white powder, usually lyophilized and often hygroscopic. It dissolves readily in water and in aqueous buffers, and it is commonly handled as the acetate or trifluoroacetate salt to improve stability during purification and drying. The amide backbone is labile in aqueous media, so solutions are less durable than the dry solid. Handling notes in the chemical literature therefore emphasize keeping the powder dry, cool and shielded from light until it is dissolved.
Epitalon is a synthetic tetrapeptide whose sequence is alanine-glutamate-aspartate-glycine, written in single-letter code as AEDG. The four residues are joined by three peptide bonds, giving a linear backbone with no branching and no disulfide bridges. Its calculated molecular mass for the free form is approximately 390.3 daltons, a figure that rises when the compound is supplied as an acetate or trifluoroacetate salt. Because the chain is short, the molecule is defined entirely by its residue order rather than by any folded three-dimensional structure.
=== Other side-effects === Less common side-effects include red skin (erythema), dry skin, damaged fingernails, a dry mouth (xerostomia), water retention, and sexual impotence. Some medications can trigger allergic or pseudoallergic reactions. Specific chemotherapeutic agents are associated with organ-specific toxicities, including cardiovascular disease (e.g., doxorubicin), interstitial lung disease (e.g., bleomycin) and occasionally secondary neoplasm (e.g., MOPP therapy for Hodgkin's disease). Hand-foot syndrome is another side effect to cytotoxic chemotherapy. Nutritional problems are also frequently seen in cancer patients at diagnosis and through chemotherapy treatment. Research suggests that in children and young people undergoing cancer treatment, parenteral nutrition may help with this leading to weight gain and increased calorie and protein intake, when compared to enteral nutrition.
== Background == The monoisotopic mass is not used frequently in fields outside of mass spectrometry because other fields cannot distinguish molecules of different isotopic composition. For this reason, mostly the average molecular mass or even more commonly the molar mass is used. For most purposes such as weighing out bulk chemicals only the molar mass is relevant since what one is weighing is a statistical distribution of varying isotopic compositions. This concept is most helpful in mass spectrometry because individual molecules (or atoms, as in ICP-MS) are measured, and not their statistical average as a whole. Since mass spectrometry is often used for quantifying trace-level compounds, maximizing the sensitivity of the analysis is usually desired. By choosing to look for the most abundant isotopic version of a molecule, the analysis is likely to be most sensitive, which enables even smaller amounts of the target compounds to be quantified. Therefore, the concept is very useful to analysts looking for trace-level residues of organic molecules, such as pesticide residue in foods and agricultural products. Isotopic masses can play an important role in physics, but physics less often deals with molecules. Molecules differing by an isotope are sometimes distinguished from one another in molecular spectroscopy or related fields; however, it is usually a single isotope change on a larger molecule that can be observed rather than the isotopic composition of an entire molecule.
== Chemistry == Carvedilol is a highly lipophilic compound with an experimental log P of 3.8 to 4.19 and a predicted log P of 3.05 to 4.2. It showed the third highest predicted lipophilicity of 30 clinically relevant beta blockers, with the second and third most lipophilic beta blockers predicted to be bopindolol and penbutolol, respectively.
==== American Indian or Alaska Native ==== The obesity rate for American Indian or Alaska Native adults (over 30 BMI) in the US in 2015 was 42.9%. However, newer research based on waist circumference suggests that the actual rate of obesity among Native Americans is approximately 80%.
=== Characteristics of elution mode === In elution mode, solutes are applied to the column as narrow bands and, at low concentration, move down the column as approximately Gaussian peaks. These peaks continue to broaden as they travel, in proportion to the square root of the distance traveled. For two substances to be resolved, they must migrate down the column at sufficiently different rates to overcome the effects of band spreading. Operating at high concentration, where the isotherm is curved, is disadvantageous in elution chromatography because the rate of travel then depends on concentration, causing the peaks to spread and distort. Retention in elution chromatography is usually controlled by adjusting the composition of the mobile phase (in terms of solvent composition, pH, ionic strength, and so forth) according to the type of stationary phase employed and the particular solutes to be separated. The mobile phase components generally have lower affinity for the stationary phase than do the solutes being separated, but are present at higher concentration and achieve their effects due to mass action. Resolution in elution chromatography is generally better when peaks are strongly retained, but conditions that give good resolution of early peaks lead to long run-times and excessive broadening of later peaks unless gradient elution is employed. Gradient equipment adds complexity and expense, particularly at large scale.
Sources: en.wikipedia.org
=== Predators === Some species of bacteria kill and then consume other microorganisms; these species are called predatory bacteria. These include organisms such as Myxococcus xanthus, which forms swarms of cells that kill and digest any bacteria they encounter. Other bacterial predators either attach to their prey in order to digest them and absorb nutrients or invade another cell and multiply inside the cytosol. These predatory bacteria are thought to have evolved from saprophages that consumed dead microorganisms, through adaptations that allowed them to entrap and kill other organisms.
=== The ascending and descending method === This is the hybrid of both of the above techniques. The upper part of ascending chromatography can be folded over a rod in order to allow the paper to become descending after crossing the rod.
Large-scale digitization programmes have made fungarium metadata increasingly available for research and public access. Digitization involves transcribing specimen information into structured databases, commonly following the Darwin Core standard maintained by the Biodiversity Information Standards community to support the sharing of biodiversity information. Electronic specimen catalogues increase the usefulness of fungaria by allowing specimens to be queried by attributes such as locality, habitat, morphology, and collector, and they can help identify taxonomic or geographic gaps in the holdings. Databasing fungarium specimens can also reveal discrepancies between literature-based inventories and voucher-backed collections, helping to show where reported diversity is not yet adequately supported by preserved material. Analysis of databased holdings may in turn guide strategic collecting by identifying underrepresented taxa and geographic areas in existing collections. Digitization may also involve retrospective georeferencing, in which textual locality descriptions on older specimen labels are translated into coordinates so that records can be mapped and analysed more effectively. The Global Biodiversity Information Facility (GBIF) is a global aggregator that uses Darwin Core Archives as a common format for publishing and distributing occurrence datasets derived from specimens and observations.
=== Luna Diabetes === Former founders of Timesulin, Welldoc, Companion Medical and Bigfoot Biomedical have joined together to create the world's first automated insulin delivery system for those that want to continue to use insulin pens. The team is calling it Episodic AID. The working product name is Luna.
It was determined that this preparation behaved anomalously in certain immunoassays and was not suitable as an IS. Three different human pituitary extracts containing prolactin were subsequently obtained as candidates for an IS. These were distributed into ampoules coded 83/562, 83/573, and 84/500. Collaborative studies involving 20 different laboratories found little difference between these three preparations. 83/562 appeared to be the most stable. This preparation was largely free of dimers and polymers of prolactin. On the basis of these investigations, 83/562 was established as the Second IS for human prolactin. Once stocks of these ampoules were depleted, 84/500 was established as the Third IS for human prolactin. 84/500 has nearly run out and in 2016 replacement was proposed. The new 83/573 contains 67.2 mIU per ampoule when calibrated against the third IS and contains 1.002 g of human pituitary extract each (which is then lyophilized). Each ampoule contains approximately 3.2 μg of prolactin. The assigned value will be 67 mIU per ampoule. If a fifth IS is needed, it will likely be based on recombinant protein, as WHO has not received any further donations of human pituitary extracts.
Sources: en.wikipedia.org
The solid is kept cold, dry and dark, typically at minus twenty degrees Celsius, in a sealed container with desiccant. Dissolved material is kept refrigerated and used promptly. Freezing and thawing a solution repeatedly is avoided because it accelerates degradation.
Reversed-phase chromatography with ultraviolet detection gives a purity percentage, while mass spectrometry confirms identity. Amino acid analysis checks the residue composition. Buyers typically request a certificate of analysis showing these measurements for the specific lot.
It is not authorised as a medicine in the United States or the European Union. Material is sold there as a research chemical or cosmetic ingredient. Some related short peptides are registered drugs in Russia, which is a distinct national situation rather than a general approval.
It is a synthetic tetrapeptide. Its sequence was derived from research on peptide fractions of bovine pineal extract, and the intact AEDG sequence has not been demonstrated as an abundant free peptide in human tissue.