This is a working overview of RP-HPLC, written for readers who want more than a one-paragraph summary but less than a textbook.
Reviewed 2026-01-29. Anything still debated is marked as such rather than presented as settled.
Laboratory-grade epitalon is typically supplied as a lyophilized powder. Purity is commonly assessed with reverse-phase high-performance liquid chromatography, often paired with mass spectrometry to confirm molecular identity. Amino acid analysis and peptide mapping can provide additional confirmation of sequence. Certificates of analysis for research materials frequently report purity above 95 percent, although the methods behind such figures vary between suppliers. The absence of a pharmacopeial monograph means that no single standardized assay defines the compound, so reported results depend on the analytical protocol chosen.
Storage recommendations center on limiting moisture, heat, and light. The dry powder is generally kept at minus 20 degrees Celsius, and some suppliers recommend minus 80 degrees for long-term archival. Once dissolved, solutions are usually aliquoted and frozen to avoid repeated freeze-thaw cycles, which can promote aggregation or degradation. Aqueous stability depends on pH and concentration, and buffered saline is often preferred over plain water for biological work. Stability data specific to epitalon remain limited, so general peptide-handling practices are applied by analogy rather than from product-specific validation.
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and its calculated monoisotopic mass is approximately 390.35 daltons. The compound does not occur naturally as a free peptide; it is produced by solid-phase peptide synthesis. Because it contains two acidic residues and no basic residues, the neutral form carries a net negative charge at physiological pH. This charge profile influences how the peptide behaves in solution and during chromatographic analysis.
Short peptides such as AEDG are normally supplied as a freeze-dried solid and are kept dry, cold, and shielded from light. Holding at minus twenty degrees Celsius is common for the long term, while a refrigerator suffices for brief periods before use. The material takes up moisture to some degree, so containers should stay sealed and be allowed to reach room temperature before opening, which limits condensation on the contents. Repeated warming and cooling of a single container is discouraged because it admits water and can lower the amount of intact peptide.
Dissolution is usually performed in water or a suitable aqueous buffer, and the resulting liquid is divided into single-use portions before freezing. Freeze-thaw cycling is a recognised source of loss for short peptides, since each cycle can encourage aggregation or adsorption onto container walls. Working solutions are generally kept cold and used within a short window, although published stability data specific to epitalon are thin. Containers should be marked with concentration and date, and solutions examined for cloudiness before use.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C14H22N4O9 | Free acid form of the tetrapeptide |
| Molecular mass | About 390.35 Da | Calculated monoisotopic value |
| Appearance | White to off-white powder | Typical lyophilized presentation |
| Solubility | Soluble in water | Also dissolves in buffered saline |
| Storage temperature | Minus 20 degrees Celsius | Dry, dark conditions; avoid repeated thawing |
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, commonly abbreviated AEDG. It was designed at the St. Petersburg Institute of Bioregulation and Gerontology as a short, chemically defined analogue of epithalamin, a fraction obtained from bovine pineal tissue. Small peptide bioregulators of this type formed a long-running line of work there from the 1980s onward. Because the molecule is produced by solid-phase synthesis rather than extraction, its composition is exact and its purity can be measured directly.
The most frequently cited proposed action is induction of telomerase, the enzyme that adds repeat sequences to chromosome ends. Cell-culture work from the originating group reported higher telomerase reverse transcriptase expression and measurable telomere elongation in human somatic cells after exposure. How a four-residue peptide would reach nuclear gene regulation is not established, and no cell-surface receptor or uptake route has been identified. Additional reports describe changes in melatonin secretion, antioxidant enzyme activity and lipid peroxidation in aged animals, but these findings remain mechanistically unconnected to the telomerase observation.
Published evidence comes mainly from Russian-language journals and from a single research group, with small sample sizes and limited independent replication. A few laboratories outside that group have examined related peptides and reported weaker or absent telomerase effects, so the central claim is best described as contested rather than settled. Rodent studies report modest changes in some ageing markers and in survival, but designs vary and control conditions are often sparse. No large randomised trial in humans has been published, and long-term safety data in healthy populations are correspondingly thin.
Solubility is high in water, phosphate-buffered saline and normal saline, a pattern that follows from the two acidic residues in the chain. The peptide dissolves poorly in non-polar solvents such as hexane or chloroform. Stock solutions are often prepared in water first and then diluted into the buffer of interest. Because the molecule is small and hydrophilic, filtration through a low-protein-binding membrane is usually straightforward, and visible particulates are uncommon in freshly made solutions.
Identity and purity are established with reversed-phase high-performance liquid chromatography and mass spectrometry. The chromatogram shows the main peak and any truncated or oxidised by-products, while the mass spectrum confirms the expected 390 dalton mass. Amino acid analysis can corroborate composition when a sample's origin is uncertain. Counterion content, particularly residual trifluoroacetate from purification, is frequently reported alongside purity because it shifts the net mass of the solid.
Material supplied for laboratory use is normally a lyophilised white to off-white powder that dissolves readily in water and in isotonic saline. Lyophilised cakes are hygroscopic and should be equilibrated to room temperature before opening to limit condensation on the solid. Solutions are typically prepared at milligram-per-millilitre concentrations and divided into single-use aliquots, because repeated freeze–thaw cycles degrade short peptides. Aqueous solutions are far less stable than the dry powder, and identity is usually verified by mass spectrometry alongside purity estimation from reversed-phase high-performance liquid chromatography.
Epitalon is a synthetic linear tetrapeptide with the sequence alanine–glutamate–aspartate–glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and the calculated mass is approximately 390.35 g/mol. The compound is made by solid-phase peptide synthesis rather than extracted from tissue, although early work described it as a short fragment of a peptide fraction obtained from bovine pineal extract. In the research literature the spelling epitalon and the variant epithalone both appear, while AEDG is the standard code used in peptide nomenclature.
Several names circulate for the same molecule, including epitalon, epithalone, epithalamin tetrapeptide, and the sequence code AEDG. A CAS registry number, 307297-39-8, is commonly cited for it, though catalogue entries should be checked against supplier documentation because mislabelled records occur. In its usual form the peptide carries free amino and carboxyl termini and is neither glycosylated nor lipidated. Researchers distinguish the defined tetrapeptide from epithalamin itself, a crude pineal preparation containing many peptides that is not chemically characterised.
Typical storage for the lyophilized powder is −20 °C or lower, in a sealed container protected from light and moisture. Hygroscopic material should be allowed to equilibrate to room temperature before the vial is opened, which limits condensation on the contents. Working solutions are commonly divided into single-use aliquots and frozen to avoid repeated freeze-thaw cycles. Dilute solutions are more prone to adsorption onto plastic surfaces and to loss during filtration, so procedures that minimize transfers and use low-binding labware are preferable.
Reversed-phase high-performance liquid chromatography is the standard approach for assessing purity, usually with ultraviolet detection near 214 nm, where the peptide bond absorbs. Mass spectrometry, most often with electrospray ionization, confirms the molecular mass and helps reveal truncation or deletion byproducts. Amino acid analysis can verify composition, and counterion content is sometimes measured because peptides purified with trifluoroacetic acid retain variable amounts of that salt. Purity figures reported without a stated method and detection wavelength are difficult to interpret.
In October 2011, a coordinated operation, Operation Linda Nchi between the Somali and Kenyan militaries and multinational forces began against the Al-Shabaab in southern Somalia. By September 2012, Somali, Kenyan, and Raskamboni forces had managed to capture Al-Shabaab's last major stronghold, the southern port of Kismayo. In July 2012, three European Union operations were launched to engage with Somalia: EUTM Somalia, EU Naval Force Somalia Operation Atalanta off the Horn of Africa, and EUCAP Nestor. As part of the official "Roadmap for the End of Transition", a political process that provided clear benchmarks leading toward the formation of permanent democratic institutions in Somalia, the Transitional Federal Government's interim mandate ended on 20 August 2012. The Federal Parliament of Somalia was concurrently inaugurated. The Federal Government of Somalia, the first permanent central government in the country since the start of the civil war, was established in August 2012 with Hassan Sheikh Mohamud elected as president. In August 2014, the Somali government-led Operation Indian Ocean was launched against insurgent-held pockets in the countryside. The next election took place in 2017 with Mohamed Abdullahi Farmajo succeeding as president. Near the end of his presidency, disagreements over the upcoming election prompted Farmajo to sign a controversial 2 year extension that was eventually overturned. In 2022, Hassan Sheikh Mohamud was re-elected for a second term.
=== Function === Nelson DL; Cox MM (2004). Lehninger Principles of Biochemistry (4th ed.). W. H. Freeman. ISBN 978-0-7167-4339-2. Bugg T (2004). Introduction to Enzyme and Coenzyme Chemistry (2nd ed.). Blackwell Publishing Limited. ISBN 978-1-4051-1452-3. Lee HC (2002). Cyclic ADP-Ribose and NAADP: Structure, Metabolism and Functions. Kluwer Academic Publishers. ISBN 978-1-4020-7281-9. Levine OS, Schuchat A, Schwartz B, Wenger JD, Elliott J (1997). "Generic protocol for population-based surveillance of Haemophilus influenzae type B" (PDF). World Health Organization. Centers for Disease Control. p. 13. WHO/VRD/GEN/95.05. Archived from the original (PDF) on 1 July 2004. Kim, Jinhyun; Lee, Sahng Ha; Tieves, Florian; Paul, Caroline E.; Hollmann, Frank; Park, Chan Beum (5 July 2019). "Nicotinamide adenine dinucleotide as a photocatalyst". Science Advances. 5 (7) eaax0501. Bibcode:2019SciA....5..501K. doi:10.1126/sciadv.aax0501. PMC 6641943. PMID 31334353.
It is advised to check the references for photos of reaction results. Reagent testers might show the colour of the desired substance while not showing a different colour for a more dangerous additive. For this reason it is essential to use multiple different tests to show all adulterants.
Sources: en.wikipedia.org
=== Other uses === Amphetamine-type stimulants and other catecholaminergic agents are known to have wakefulness-promoting effects and are used in the treatment of hypersomnia and narcolepsy. Pseudoephedrine at therapeutic doses does not appear to improve or worsen daytime sleepiness, daytime fatigue, or sleep quality in people with allergic rhinitis. Likewise, somnolence was not lower in children with the common cold treated with pseudoephedrine for nasal congestion. In any case, insomnia is a known side effect of pseudoephedrine, although the incidence is low. In addition, doses of pseudoephedrine above the normal therapeutic range have been reported to produce stimulant effects including insomnia and fatigue resistance. There has been interest in pseudoephedrine as an appetite suppressant for the treatment of obesity. However, due to lack of clinical data and potential cardiovascular side effects, this use is not recommended. Only a single placebo-controlled study of pseudoephedrine for weight loss exists (120 mg/day slow-release for 12 weeks) and found no significant difference in weight lost compared to placebo (-4.6 kg vs. -4.5 kg). This was in contrast to phenylpropanolamine, which has been found to be more effective at promoting weight loss compared to placebo and has been more widely studied and used in the treatment of obesity. Pseudoephedrine has been used limitedly in the treatment of orthostatic intolerance including orthostatic hypotension and postural orthostatic tachycardia syndrome (POTS).
Automated iterative homologation enables stepwise construction of carbon chains through repeated one-carbon extensions of boronic esters. Two reactions adapted to automation are the Matteson homologation, which inserts a methylene unit via chloromethyllithium, and chiral carbenoid homologation, which uses lithiated benzoate esters. Both methods have been implemented on robotic platforms under low-temperature, inert conditions. Using these techniques, up to six consecutive C(sp³)–C(sp³) bond-forming homologations have been performed without manual intervention, representing the highest number reported in an automated synthesis. The approach has also been applied to the synthesis of intermediates of the natural product (+)-kalkitoxin.
24395Am + 188O → 261103Lr* → 256103Lr + 5 10n Further experiments in 1969 at Dubna, and in 1970 at Berkeley, demonstrated an actinide chemistry for the new element; so by 1970 it was known that element 103 is the last actinide. In 1970, the Dubna group reported the synthesis of 255Lr with half-life 20 s and alpha decay energy 8.38 MeV. However, it was not until 1971, when the nuclear physics team at University of California at Berkeley successfully did a whole series of experiments aimed at measuring the nuclear decay properties of the lawrencium isotopes with mass numbers 255 to 260, that all previous results from Berkeley and Dubna were confirmed, apart from the Berkeley's group initial erroneous assignment of their first produced isotope to 257Lr instead of the probably correct 258Lr. All final doubts were dispelled in 1976 and 1977 when the energies of X-rays emitted from 258Lr were measured.
Sources: en.wikipedia.org
Epitalon is a synthetic tetrapeptide built from four amino acids: alanine, glutamate, aspartate, and glycine. It is not extracted from a natural source but made in the laboratory by chemical synthesis. Its short length makes it relatively straightforward to produce at high purity.
No naturally occurring free form of the peptide has been described. The four-amino-acid sequence can appear as a fragment within larger proteins, but that is not the same as the intact compound being present as a circulating molecule. Materials used in research are synthetic.
Purity is usually checked by reverse-phase high-performance liquid chromatography, which separates the target peptide from related impurities. Mass spectrometry is commonly used alongside it to confirm molecular mass. Some suppliers also provide amino acid analysis for additional sequence confirmation.
Reversed-phase high-performance liquid chromatography is run alongside mass spectrometry. The chromatogram separates components and gives a purity figure, while the mass spectrum confirms that the measured molecular mass matches the expected sequence. Neither measurement on its own is treated as sufficient.