If you have been reading about lyophilized powder and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Updated 2026-06-14. Numbers and descriptions here follow the published literature rather than marketing material.
Storage practice centres on limiting moisture, oxygen, and repeated temperature cycling. Freeze-dried powder is generally held desiccated at minus twenty degrees Celsius or colder and protected from light. Reconstituted solutions are markedly less stable, and the aspartate-glycine junction is prone to succinimide formation at neutral to mildly alkaline pH. Portioning material into single-use aliquots reduces degradation compared with repeated freeze-thaw cycles. Stability data specific to this tetrapeptide remain scarce, so most handling guidance is extrapolated from general peptide chemistry rather than measured directly.
Documentation accompanying research peptides usually includes a certificate of analysis listing the batch number, purity figure, and test methods applied. Buyers comparing suppliers should check whether the reported purity refers to chromatographic area or to a mass-balance calculation, because the two are not equivalent. Counter-ion content, residual solvents, and water content are sometimes omitted from such certificates even though they affect the actual peptide mass present. Independent verification through a second laboratory is the most direct way to confirm that a supplied material matches its label.
Storage recommendations center on limiting moisture, heat, and light. The dry powder is generally kept at minus 20 degrees Celsius, and some suppliers recommend minus 80 degrees for long-term archival. Once dissolved, solutions are usually aliquoted and frozen to avoid repeated freeze-thaw cycles, which can promote aggregation or degradation. Aqueous stability depends on pH and concentration, and buffered saline is often preferred over plain water for biological work. Stability data specific to epitalon remain limited, so general peptide-handling practices are applied by analogy rather than from product-specific validation.
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and its calculated monoisotopic mass is approximately 390.35 daltons. The compound does not occur naturally as a free peptide; it is produced by solid-phase peptide synthesis. Because it contains two acidic residues and no basic residues, the neutral form carries a net negative charge at physiological pH. This charge profile influences how the peptide behaves in solution and during chromatographic analysis.
Laboratory-grade epitalon is typically supplied as a lyophilized powder. Purity is commonly assessed with reverse-phase high-performance liquid chromatography, often paired with mass spectrometry to confirm molecular identity. Amino acid analysis and peptide mapping can provide additional confirmation of sequence. Certificates of analysis for research materials frequently report purity above 95 percent, although the methods behind such figures vary between suppliers. The absence of a pharmacopeial monograph means that no single standardized assay defines the compound, so reported results depend on the analytical protocol chosen.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Freeze-dried solid |
| Solubility class | Freely soluble in water | Aqueous buffers also suitable |
| Typical storage temperature | Minus 20 degrees Celsius or colder | Desiccated and light protected |
| Typical analytical method | RP-HPLC with UV detection | 214 nm on C18 column |
| Identity confirmation | Electrospray mass spectrometry | Sequence verified separately |
Regulatory status varies by country and is not harmonized. Epitalon is not an approved drug in major Western jurisdictions. In some countries it is sold as a research chemical, and in others it has appeared in products marketed for other categories. This inconsistent status means that purity, labeling accuracy, and documentation differ widely between suppliers, and verification of identity and purity through independent analysis is the usual way buyers assess a given lot.
Epitalon appears in the literature primarily through a small number of research groups, most of them associated with the St. Petersburg Institute of Bioregulation and Gerontology. Publications describe cell culture experiments, animal studies, and a limited number of small human studies. Independent replication outside this network is sparse. As a result, reviews of the topic usually separate descriptive reports of observed effects from the question of whether those effects generalize, and they note the difficulty of comparing studies that use different preparations and endpoints.
In its supplied form epitalon is a white to off-white powder, usually lyophilized and often hygroscopic. It dissolves readily in water and in aqueous buffers, and it is commonly handled as the acetate or trifluoroacetate salt to improve stability during purification and drying. The amide backbone is labile in aqueous media, so solutions are less durable than the dry solid. Handling notes in the chemical literature therefore emphasize keeping the powder dry, cool and shielded from light until it is dissolved.
Epitalon is a synthetic tetrapeptide whose sequence is alanine-glutamate-aspartate-glycine, written in single-letter code as AEDG. The four residues are joined by three peptide bonds, giving a linear backbone with no branching and no disulfide bridges. Its calculated molecular mass for the free form is approximately 390.3 daltons, a figure that rises when the compound is supplied as an acetate or trifluoroacetate salt. Because the chain is short, the molecule is defined entirely by its residue order rather than by any folded three-dimensional structure.
The compound is described in the literature as a derivative of epithalamin, a preparation obtained from bovine pineal tissue. Work on this peptide family was carried out mainly by a research group in Saint Petersburg beginning in the 1980s, and the substance was later registered for clinical use in Russia under the name Epitalon. Outside that region it is generally treated as a research chemical rather than an approved medicine. Statements about its biological activity rest on a relatively small number of studies, and independent replication remains limited.
=== Baculovirus === Baculovirus, a rod-shaped virus which infects insect cells, is used as the expression vector in this system. Insect cell lines derived from Lepidopterans (moths and butterflies), such as Spodoptera frugiperda, are used as host. A cell line derived from the cabbage looper is of particular interest, as it has been developed to grow fast and without the expensive serum normally needed to boost cell growth. The shuttle vector is called bacmid, and gene expression is under the control of a strong promoter pPolh. Baculovirus has also been used with mammalian cell lines in the BacMam system. Baculovirus is normally used for production of glycoproteins, although the glycosylations may be different from those found in vertebrates. In general, it is safer to use than mammalian virus as it has a limited host range and does not infect vertebrates without modifications.
=== Arrays === Lectin and antibody arrays provide high-throughput screening of many samples containing glycans. This method uses either naturally occurring lectins or artificial monoclonal antibodies, where both are immobilized on a certain chip and incubated with a fluorescent glycoprotein sample. Glycan arrays, like that offered by the Consortium for Functional Glycomics and Z Biotech LLC, contain carbohydrate compounds that can be screened with lectins or antibodies to define carbohydrate specificity and identify ligands.
Removal of a proton from an aliphatic –OH group is difficult to achieve in aqueous solution because the energy required for this process is rather large. Thus, ionization of aliphatic –OH groups occurs in aqueous solution only in special circumstances. One such circumstance is found with compounds containing the H2N–C–C–OH substructure. For example, compounds containing the 2-aminoethanol substructure can form metal–chelate complexes with the deprotonated form, H2N–C–C–O−. The chelate effect supplies the extra energy needed to break the O–H bond. An important example occurs with the molecule tris. This molecule should be used with caution as a buffering agent as it will form chelate complexes with ions such as Fe3+ and Cu2+.
== Further reading == Slater, Anna G.; Cooper, Andrew I. (2015-05-29). "Function-led design of new porous materials". Science. 348 (6238) aaa8075. doi:10.1126/science.aaa8075. PMID 26023142. Satoh, Yusuke; Matsuno, Hirohiko; Yamamato, Takuya; Tajima, Kenji; Isono, Takuya; Satoh, Toshifumi (2017). "Synthesis of Well-Defined Three- and Four-Armed Cage-Shaped Polymers via "Topological Conversion" from Trefoil- and Quatrefoil-Shaped Polymers". Macromolecules. 50 (1): 97–106. Bibcode:2017MaMol..50...97S. doi:10.1021/acs.macromol.6b02316. Mato, Yoshinobu; Honda, Kohei; Tajima, Kenji; Yamamato, Takuya; Isono, Takuya; Satoh, Toshifumi (2019). "A versatile synthetic strategy for macromolecular cages: intramolecular consecutive cyclization of star-shaped polymers". Chemical Science. 10 (2): 440–446. doi:10.1039/C8SC04006K. PMC 6335864. PMID 30746091. Lee, Taeheon; Oh, Joongsuk; Jeong, Jonghwa; Jung, Haeji; Huh, June; Chang, Taihyun; Paik, Hyun-jong (2016-05-24). "Figure-Eight-Shaped and Cage-Shaped Cyclic Polystyrenes". Macromolecules. 49 (10): 3672–3680. Bibcode:2016MaMol..49.3672L. doi:10.1021/acs.macromol.6b00093. ISSN 0024-9297.
The initiative's sponsor associations include United Fresh Produce Association (United Fresh), Canadian Produce Marketing Association (CPMA) and Produce Marketing Association (PMA). Both internal and external traceability programs are needed in order to effectively track and trace product up and down the supply chain, achieving whole-chain traceability. At present, most companies have internal traceability programs but not external traceability. The PTI outlines a six-step course of action to achieve chain-wide adoption of electronic traceability of every case produce by the year 2012. Meanwhile, companies are putting into operation technologies that will support the PTI.
Sources: en.wikipedia.org
The original fragile and heavy glass containers presented challenges for transportation, and glass jars were largely replaced in commercial canneries with cylindrical tin can or wrought-iron canisters (later shortened to "cans") following the work of Peter Durand (1810). Cans are cheaper and quicker to make, and much less fragile than glass jars. Can openers were not invented for another thirty years. At first, soldiers would cut the cans open with bayonets or smash them open with rocks. Today, tin-coated steel is the material most commonly used. Aseptically processed retort pouches are also used for canning. Glass jars have remained popular for some high-value products and in home canning.
The digital signal is transmitted using OFDM with the HDC (High-Definition Coding) proprietary audio compression format. HDC is based on, but not compatible with, the MPEG-4 standard HE-AAC. It uses a modified discrete cosine transform (MDCT) audio data compression algorithm. Digital Radio Mondiale (DRM) is a competing digital terrestrial radio standard developed mainly by broadcasters as a higher spectral efficiency replacement for legacy AM and FM broadcasting. Mondiale means "worldwide" in French and Italian; DRM was developed in 2001, and is currently supported by 23 countries, and adopted by some European and Eastern broadcasters beginning in 2003. The DRM30 mode uses the commercial broadcast bands below 30 MHz, and is intended as a replacement for standard AM broadcast on the longwave, mediumwave, and shortwave bands. The DRM+ mode uses VHF frequencies centered around the FM broadcast band, and is intended as a replacement for FM broadcasting. It is incompatible with existing radio receivers, so it requires listeners to purchase a new DRM receiver. The modulation used is a form of OFDM called COFDM in which, up to 4 carriers are transmitted on a channel formerly occupied by a single AM or FM signal, modulated by quadrature amplitude modulation (QAM). The DRM system is designed to be as compatible as possible with existing AM and FM radio transmitters, so that much of the equipment in existing radio stations can continue in use, augmented with DRM modulation equipment.
Similarly, researchers from the Technical University of Munich and LMU Munich have developed a method to have T-cells target tumor cells by using antigen coated DNA origami. The researchers developed a method to create chassis known as programmable T-cell Engagers (PTEs) which are DNA origami structures that can be configured to bind to user-defined target cells and T-cells based on which antigens are coated on the surfaces of the nanostructure. The in vitro results show that after 24 hours of exposure 90% of the tumor cells were destroyed. Meanwhile, in vivo testing showed that their PTEs were capable of binding to the target proteins for several hours which validates the mechanism they designed.
Levamisole, sold under the brand name Ergamisol among others, is a medication used to treat parasitic worm infections, specifically ascariasis and hookworm infections. It is taken by mouth. Side effects may include abdominal pain, vomiting, headache, and dizziness. Use is not recommended during breastfeeding or the third trimester of pregnancy. Serious side effects may include an increased risk of infection. It belongs to the anthelmintic class of medications. Levamisole was invented in 1966 in Belgium by Janssen Pharmaceuticals. It is on the World Health Organization's List of Essential Medicines. Levamisole is also used as a dewormer for cattle. It is also often used as a cutting agent in illegal cocaine. In February 2026, the Pharmacovigilance Risk Assessment Committee of the European Medicines Agency recommended that medicines containing levamisole be withdrawn from the EU market. This follows an EU-wide review which concluded that the benefits of these medicines no longer outweigh their risks for the treatment of parasitic worm infections in adults and children.
Allan Maxam and Walter Gilbert published a DNA sequencing method in 1977 based on chemical modification of DNA and subsequent cleavage at specific bases. Also known as chemical sequencing, this method allowed purified samples of double-stranded DNA to be used without further cloning. This method's use of radioactive labeling and its technical complexity discouraged extensive use after refinements in the Sanger methods had been made. Maxam-Gilbert sequencing requires radioactive labeling at one 5' end of the DNA and purification of the DNA fragment to be sequenced. Chemical treatment then generates breaks at a small proportion of one or two of the four nucleotide bases in each of four reactions (G, A+G, C, C+T). The concentration of the modifying chemicals is controlled to introduce on average one modification per DNA molecule. Thus a series of labeled fragments is generated, from the radiolabeled end to the first "cut" site in each molecule. The fragments in the four reactions are electrophoresed side by side in denaturing acrylamide gels for size separation. To visualize the fragments, the gel is exposed to X-ray film for autoradiography, yielding a series of dark bands each corresponding to a radiolabeled DNA fragment, from which the sequence may be inferred. This method is mostly obsolete as of 2023.
Sources: en.wikipedia.org
Reversed-phase high-performance liquid chromatography with ultraviolet detection at 214 nanometres is the usual approach. Peak area percentage provides a purity figure relative to other components in the sample. Mass spectrometry is then applied to confirm identity.
Aspartate can cyclise into a succinimide intermediate that later hydrolyses back as isoaspartate. Both forms share the same molecular mass, so mass spectrometry alone cannot tell them apart. This shapes how purity data should be interpreted.
Freeze-dried material is normally kept desiccated below minus twenty degrees Celsius and shielded from light. Solutions are prepared shortly before use and held cold. Repeated thawing is avoided because it accelerates aggregation and degradation.
Epitalon is a synthetic tetrapeptide built from four amino acids: alanine, glutamate, aspartate, and glycine. It is not extracted from a natural source but made in the laboratory by chemical synthesis. Its short length makes it relatively straightforward to produce at high purity.