A practical reference on counterion: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2026-08-01 and is reviewed periodically as new material appears.
The peptide emerged from research carried out in Saint Petersburg from the late 1980s onward, where investigators searched for shorter active fragments of a pineal preparation known as epithalamin. The name epitalon was chosen to reflect that parent extract. Early reports described effects on neuroendocrine markers and on the lifespan of laboratory animals. Much of that work appeared in Russian-language journals, with English translations following later, which affects how readily the original protocols can be assessed by outside groups.
Published studies on epitalon are dominated by a small number of research groups, and independent replication in other laboratories remains limited. Proposed mechanisms include activation of telomerase and modulation of melatonin rhythms, but the evidence for either rests mainly on cell cultures and animal models. Whether the peptide produces comparable effects in humans is an open question, and the absence of large controlled trials means the literature is best read as exploratory rather than settled.
Verification of a sample usually begins with reversed-phase high-performance liquid chromatography, which resolves the peptide from truncated sequences and other impurities and expresses purity as a percentage of total peak area. Mass spectrometry by electrospray ionisation or matrix-assisted laser desorption supplies an independent check, because the measured mass can be compared against the theoretical value for AEDG. Amino acid analysis or tandem mass spectrometry sequencing can confirm residue order. Each of these methods answers a different question: a purity figure does not establish identity, and an identity match does not establish how much of the material is intact peptide.
The molecule is a short, linear, hydrophilic peptide that dissolves readily in water or aqueous buffer. Its principal chemical liabilities are hydrolytic rather than oxidative, since it contains no cysteine, methionine, or tryptophan residues. The aspartate–glycine step is a recognised site for aspartimide formation under mildly acidic or basic conditions, generating isoaspartate and succinimide-related products over time. Desiccated lyophilised powder held at −20 °C is comparatively stable, whereas dilute solutions degrade faster and are best frozen as single-use aliquots rather than thawed repeatedly.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C14H22N4O9 | Derived from the four-residue sequence |
| Molar mass | About 390.35 g/mol | Free peptide, counter-ion not included |
| Appearance | White to off-white powder | Lyophilised solid from aqueous solution |
| Water solubility | Freely soluble | Short, polar peptide chain |
| Common synonyms | AEDG; epithalone | Catalogues use the names interchangeably |
Interest in epitalon is usually discussed within the broader field of short peptide bioregulators, a category that includes other synthetic di-, tri-, and tetrapeptides studied by the same research group. These compounds share a common rationale: that small fragments of tissue-derived proteins can retain biological activity and can be produced reproducibly. The category as a whole remains outside mainstream pharmacological consensus, and epitalon specifically has a limited presence in independent, non-Russian research literature, which shapes how its evidence base is described.
Epitalon is a synthetic tetrapeptide with the amino acid sequence alanine-glutamate-aspartate-glycine, abbreviated Ala-Glu-Asp-Gly or AEDG. It was developed by the Russian researcher Vladimir Khavinson and colleagues during work on peptide bioregulators derived from the pineal gland. The compound is short enough to be produced by standard solid-phase peptide synthesis and is typically handled as a lyophilized white powder. Its small size distinguishes it from larger pineal peptides such as epithalamin, a complex extract from which the tetrapeptide was conceptually derived.
The four residues give epitalon a molecular formula of C14H22N4O9 and a molecular weight near 390.35 daltons. The presence of two acidic residues, glutamate and aspartate, makes the free peptide strongly acidic, while the alanine and glycine ends provide neutral, nonpolar character. This combination produces a molecule with substantial water solubility. Because there are no cysteine, methionine, or tryptophan residues, the peptide lacks the most common oxidation-sensitive side chains, which simplifies handling compared with many longer peptides.
Solubility is high in water, phosphate-buffered saline and normal saline, a pattern that follows from the two acidic residues in the chain. The peptide dissolves poorly in non-polar solvents such as hexane or chloroform. Stock solutions are often prepared in water first and then diluted into the buffer of interest. Because the molecule is small and hydrophilic, filtration through a low-protein-binding membrane is usually straightforward, and visible particulates are uncommon in freshly made solutions.
Identity and purity are established with reversed-phase high-performance liquid chromatography and mass spectrometry. The chromatogram shows the main peak and any truncated or oxidised by-products, while the mass spectrum confirms the expected 390 dalton mass. Amino acid analysis can corroborate composition when a sample's origin is uncertain. Counterion content, particularly residual trifluoroacetate from purification, is frequently reported alongside purity because it shifts the net mass of the solid.
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and its calculated monoisotopic mass is approximately 390.35 daltons. The compound does not occur naturally as a free peptide; it is produced by solid-phase peptide synthesis. Because it contains two acidic residues and no basic residues, the neutral form carries a net negative charge at physiological pH. This charge profile influences how the peptide behaves in solution and during chromatographic analysis.
Laboratory-grade epitalon is typically supplied as a lyophilized powder. Purity is commonly assessed with reverse-phase high-performance liquid chromatography, often paired with mass spectrometry to confirm molecular identity. Amino acid analysis and peptide mapping can provide additional confirmation of sequence. Certificates of analysis for research materials frequently report purity above 95 percent, although the methods behind such figures vary between suppliers. The absence of a pharmacopeial monograph means that no single standardized assay defines the compound, so reported results depend on the analytical protocol chosen.
Storage recommendations center on limiting moisture, heat, and light. The dry powder is generally kept at minus 20 degrees Celsius, and some suppliers recommend minus 80 degrees for long-term archival. Once dissolved, solutions are usually aliquoted and frozen to avoid repeated freeze-thaw cycles, which can promote aggregation or degradation. Aqueous stability depends on pH and concentration, and buffered saline is often preferred over plain water for biological work. Stability data specific to epitalon remain limited, so general peptide-handling practices are applied by analogy rather than from product-specific validation.
=== Physical properties === A lutetium atom has 71 electrons, arranged in the configuration [Xe] 4f145d16s2. Lutetium is generally encountered in the +3 oxidation state, having lost its two outermost 6s and the single 5d-electron. The lutetium atom is the smallest among the lanthanide atoms, due to the lanthanide contraction, and as a result lutetium has the highest density, melting point, and hardness of the lanthanides. As lutetium's 4f orbitals are highly stabilized only the 5d and 6s orbitals are involved in chemical reactions and bonding; thus it is characterized as a d-block rather than an f-block element, and on this basis some consider it not to be a lanthanide at all, but a transition metal like its lighter congeners scandium and yttrium.
=== Intestinal biopsy === An intestinal biopsy must confirm lactase deficiency following discovery of elevated hydrogen in the hydrogen breath test. Modern techniques have enabled a bedside test, identifying presence of lactase enzyme on upper gastrointestinal endoscopy instruments. However, for research applications such as mRNA measurements, a specialist laboratory is required.
== Production and properties == Butyl acrylate can be produced by the acid-catalyzed esterification of acrylic acid with butanol. It polymerizes easily, therefore commercial preparations contain polymerization inhibitors such as hydroquinone, phenothiazine, or hydroquinone ethyl ether.
Sources: en.wikipedia.org
Once the heterologous protein has been fused with the bacterial cell surface protein, it is exposed to either an enzyme, a cell (expressing a target protein) or an antibody (usually fluorescently tagged), depending on the application of the experiment. The sample is then passed through a beam of light during FACS, in a very narrow stream of fluid so that only one cell can pass at a time, and the fluorescence emitted is detected. Information on the size of the cell can be obtained by the scattering of light and if binding of the heterologous protein with the target protein/cell has occurred, there will be more fluorescence emitted. Bacterial surface display can be used for a variety of applications. These include affinity-based screening, antibody epitope mapping, the identification of peptide substrates, the identification of cell-binding peptides and vaccine generation.
Because of its central role in controlling eukaryotic gene expression, P-TEFb is subject to stringent regulation at the level of transcription of the genes encoding the subunits, translation of the subunit mRNAs, turnover of the subunits, and also by an unusual mechanism involving the 7SK snRNP. As shown in Figure 3 P-TEFb is held in the 7SK snRNP by the double stranded RNA binding protein HEXIM (HEXIM1 or HEXIM2 in humans). HEXIM bound to 7SK RNA or any double stranded RNA binds to P-TEFb and inhibits the kinase activity. Two other proteins are always found associated with 7SK RNA. The methyl phosphase capping enzyme MEPCE puts a methyl group on the gamma phosphate of the first nucleotide of the 7SK RNA and the La related protein LARP7 binds to the 3' end of 7SK. When P-TEFb is extracted from the 7SK snRNP, 7SK RNA undergoes a conformation change, HEXIM is ejected and hnRNPs take the place of the factors removed. The re-sequestration of P-TEFb requires another rearrangement of the RNA, binding of HEXIM and then P-TEFb. In rapidly growing cells the 7SK snRNP is the predominant form of P-TEFb. For review.
Femarelle is a dietary supplement range containing DT56a, a tofu-derived soy extract, together with additional ingredients including flaxseed powder, vitamins, and minerals. DT56a has been studied for its potential activity as a selective estrogen receptor modulator (SERM), meaning that it may interact selectively with estrogen receptors in different tissues. Femarelle has been evaluated in several clinical studies investigating its possible role in supporting women during menopause, including studies on menopausal symptoms, vaginal health, bone health, and safety profile. Some studies reported encouraging findings, including improvements in menopausal symptoms and a favorable safety profile compared with traditional hormone replacement therapy, although the published trials were generally limited by relatively small sample sizes and short study durations. In 2008, an application was submitted to the European Food Safety Authority (EFSA) regarding a health claim related to bone mineral density and osteoporosis risk. EFSA concluded that the available evidence at that time was insufficient to establish a cause-and-effect relationship between Femarelle consumption and improvements in bone mineral density or reduction of osteoporosis risk in postmenopausal women.
Sources: en.wikipedia.org
It is a synthetic tetrapeptide built from alanine, glutamate, aspartate and glycine. The four residues are joined by standard peptide bonds, giving a linear chain rather than a branched structure.
The name derives from epithalamin, a pineal gland extract studied in the former Soviet Union. Researchers proposed that short fragments of that extract carried the biological activity of interest.
No major regulatory agency has approved it as a medicine. It is handled as a research chemical, and products sold under this name are not standardised drugs with defined clinical labelling.
Mass spectrometry provides the identity check, because the observed mass is compared with the theoretical mass of the AEDG sequence. Chromatography separates and quantifies impurities but does not by itself prove which peptide is present. The two techniques are normally used together.